Tim kindly shared this helpful information with me. If you have a sensor light that shuts off too quickly, you can adjust the time it waits before turning off when it doesn’t detect someone in the room. The process is straightforward.

1. To start the programming process, press and hold the bottom (where you would push to switch the light on/off) for 10 seconds.
2. The LED will blink 5 times.
3. Push on the on/off button once and the LED will flash 2 times, that indicates a 5 minute delay.
4. Push on the on/off button once and the LED will flash 3 times, that indicates a 10 minute delay.
5. Push on the on/off button once and the LED will flash 4 times, that indicates a 15 minute delay.
6. Push on the on/off button once and the LED will flash 5 times, that indicates a 20 minute delay.
7. No push and hold the button for 10 seconds to exit adjustment mode and save your changes.

You’re all set!  Below is a copy of the settings table from the Legrand site if you want to keep that with you while you are setting your delays.